Technical Specs and System Requirements
Category |
HARDWARE AND SOFTWARE MINIMUM REQUIREMENTS |
|---|---|
iOS version |
Tested with iOS versions 4.3, 5.0, 5.1, 6.0, 6.0.1, 6.0.2, 6.1 iOS 4.3 or later IS REQUIRED! (App version 1.7+). This is an Apple requirement (not Dashboss) for all App submissions since the rollout of iOS 6.0. Apple will reject any submissions that support the older iOS/hardware versions. This affects the HARDWARE requirement listed below. |
Hardware |
iPhone® with ARMv7 or later processor which includes:
iPad® with ARMv7 or later processor which includes:
iPod touch® with ARMv7 or later processor RUNNING iOS4.3 or later … which includes:
**iPod touch® and iPad® WiFi will NOT HAVE GPS functions available, however “Location Services” if enabled may be used for approximate positioning. |
BlueTooth |
*REQUIRED* |
Table 1. iPhone®/iPod touch®/iPad® Requirements
Category |
Value |
|---|---|
Operating Temperature |
-40 degrees C to 85 degrees C |
Storage Temperature |
-40 degrees C to 85 degrees C |
Operating Humidity |
<90% |
Storage Humidity |
<90% |
Input/Output Analog |
Two channels: 0-5 volts MAX |
Universal Serial Bus (USB) |
USB 2.0 compliant |
Vehicle Communication |
Controller Area Network (CAN) – 11bit and 29bit compliant, 500 kps, ISO 11898, ISO 15765, SAE J1978, SAE J1979 |
Processor |
72 MHz ARM 32 bit RISC microprocessor |
Radio |
Radio USA FCC CFR47 Part 15 C, para 15.247FCC ID: T9J-R41-1EUROPE EN 300 328-1EN 300 328-2 2.4GHzCANADA IC RSS-210 low power comm. deviceIC Canada ID: 6514A-RN411 |
EMC |
USA FCC CFR47 Part 15 subclass BEUROPE EN 55022 Class B radiatedEN61000-4-2 ESD immunityEN61000-4-3 radiated fieldEN61000-4-6 RF immunityEN61000-4-8 power magnetic immunity |
BlueTooth |
LISTED B013180 |
FCC Part 15CE Warning |
FCC WarningThe DashBoss Gateway has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These standards are designed to provide reasonable protection against harmful interference when these devices are operated in a residential environment. These devices generate, use, and can radiate radio frequency energy and may cause harmful interference to radio communications unless installed in accordance with this User’s Guide. However, there is no guarantee that intereference will not occur in a particular installation. If this equipment does cause harmful interference, which can be determined by turning the equipment off and on, the user is obligated to mitigate the interference at his or her own expense. The user is encouraged to try to correct any interefence by relocating the unit or consulting an expert radio or TV technician. The equipment compies with FCC radiation exposure limit set forth for uncontrolled Environment. Changes or modifications to this equipment not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.CE Mark WarningThese are Class B products. In a domestic environment these products may cause radio interference in which case the user will need to consider adequate preventative methods. |
Table 2. Gateway Operating Specifications


